Chat with us, powered by LiveChat

10 Do's and Don'ts for Spray Adhesives

Posted by Lynne 05/07/2019 0 Comment(s) Adhesive Products,

We sell a wide range of spray contact adhesives, which are ideal for delivering istant and high-strength bonds on a range of materials. Continue reading to find out 10 do's and don'ts for when working with spray adhesives.

 

Here's what not to do, when using spray adhesives:

  1. Don't close the thumb screw off when the hose and gun is connected, otherwise the glue will cure in the hose.
  2. Don't overapply adhesive, too much glue doesn't improve the bond.
  3. Don't bring the two substrates together immediatley after sparying the glue. This will trap solvent and cause delamination.
  4. Don't use conventional general purpose spray adhesive for bonding polystyrene, we have an alternative for this. 
  5. Don't leave the gun and hose off the canister.

Here's what you should do, when using spray adhesives:

  1. Spray adhesive evenly.
  2. Hold the gun about 15-20 cm from the substrate being sprayed.
  3. Leave sprayed up substrates apart for 4-6 mins*.
  4. Use a laminating roller to ensure all areas have bonded together.
  5. Keep the gun tip clean with cleaner, to prevent clogging.
Click here to Downlad our Spray Manual

 

Require some further advice? Our technical team at Adkwik, have a great understanding of these products and can provide top professional advice.

Click here for a Callback in 28 seconds | Call us now: 01223 412373 | email: sales@adwkik.co.uk | Live Chat

 
*This time may vary depending on product, always consult the technical data sheet before use.