TensorGrip L17 is a premium quality spray contact adhesive with a unique resin formula which creates a tough and resilient bond line. TensorGrip  ... Click to view
TensorGrip L17 is a premium quality spray contact adhesive with a unique resin formula which creates a tough and resilient bond line. TensorGrip L17 is suitable for bonding plastic laminates, GRP, Rubbers and many other materials to MDF, chipboard, plywood and many other timber based materials.
TensorGrip L17 is designed for permanent bonding where immediate bond strength and high heat resistance is required. Can also be used for bonding sheet metals.
TensorGrip L17 has a extremely high heat resistance of 128°C and is Class 1 Fire Rated.
Tensorgrip L17 is a high performance contact adhesive with a unique resin formula which creates a tough and resilient bond line between decorative surface materials and all common wood substrates. Tensorgrip L17 is suitable for bonding HPL and fabrics to a variety of substrates including MDF, chipboard, plywood and many other timber sheet materials. Tensogrip L17 is designed for permanent bonding of materials where immediate bond strength and high heat resistance an required. Tensorgrip L17 is designed for permanent bonding of materials where immediate bond strength and high heat resistance are required. Tensorgrip L17 can also be used for bonding sheet metals, where surface preparation is very important - surface must be degreased and lightly abraded with fine abrasive or non-woven material.
Material Safety Data Sheets and Technical Data Sheets must be read and understood before use.
Make sure that surfaces are clean, dry and free from dirt, dust, oil, loose paint, wax or grease, etc. For best results the temperature of the adhesive and the surfaces being bonded should be between 16°C - 27°C
When possible we recommend shaking the aerosol well before using.
Prior to use check compatibility by spraying a small test patch of the adhesive on the substrate. This product may degrade some substrates.
Spray about 10-20cm away at a 90° angle to the surface applying a uniform even coat of adhesive to obtain 80% to 100% coverage of the surface. If necessary spray another coat of adhesive in areas that appear to need more adhesive. Spray both surfaces to be bonded, one surface vertically and the other surface horizontally. Allow the adhesive to tack off until no adhesive transfer to the knuckle when touched.
Adhere surfaces and press together with adequate pressure. A roller is recommended to apply a uniform pressure to achieve maximum strength. Allow 24 hours for the adhesive to fully cure.
Canister Storage/Change Over
Turn valve on canister into the off position, spray out remaining adhesive left in the hose, disconnect the spray hose and gun from the canister. Reconnect the spray hose to a canister of solvent (sold separately) and spray out until liquid is clear which indicates that the hose and gun is clean. If you choose to leave the hose and spray gun on the canister leave the valve on the canister open. Do not disconnect the hose/gun from the canister. Close and lock the spray gun.
For removing excess glue use Tensorgrip C101.
Shelf life: 18 months from date of manufacture.
Do not store at temperatures over 50°C. For optimum performance store at 18°C during use but must always be above 10°C
Avoid exposure to direct sunlight. Do not store directly on concrete floor.
When connected keep valve open and hose pressurised at all times. Do not close valve until ready to connect to new cylinder.
Added To Basket
Free delivery on orders over £100.00 placed before 3.30PM