Adkwik sells a wide range of spray contact adhesives, which are ideal for delivering instant and high-strength bonds on a range of materials. Continue reading to find out 10 do’s and don’ts for when working with spray adhesives and you can also download our spray manual here.
Here’s what not to do, when using spray adhesives:
- Don’t close the thumb screw off when the hose and gun is connected, otherwise, the glue will cure in the hose.
- Don’t overapply adhesive, too much glue doesn’t improve the bond.
- Don’t bring the two substrates together immediately after spraying the glue. This will trap solvent and cause delamination.
- Don’t use conventional general purpose spray adhesive for bonding polystyrene, we have an alternative for this.
- Don’t leave the gun and hose off the canister.
Here’s what you should do, when using spray adhesives:
- Spray adhesive evenly.
- Hold the gun about 15-20 cm from the substrate being sprayed.
- Leave sprayed up substrates apart for 4-6 mins*.
- Use a laminating roller to ensure all areas have bonded together.
- Keep the gun tip clean with cleaner, to prevent clogging.
CLICK HERE TO DOWNLOAD OUR SPRAY MANUAL
Require some further advice?
Our technical team at Adkwik, have a great understanding of these products and can provide you with all the advice you need to get you started with spray adhesives.
Click here for a Callback in 28 seconds | Call us now: 01223 412373 | Email us here online| Live Chat